Heat Treatment Systems for Cylinder Heads and Engine Blocks

The system consists of the loading section (forklift loading area), the solution annealing furnace, the water quench, the artificial ageing furnace and an unloading section. The air inside the furnace is recirculated by means of powerful fans. Energy efficiency and maintenance-friendliness were key considerations in designing this system.

The furnace atmosphere is directly heated by natural gas burners. The artificial ageing furnace is commonly operated in the 160 – 240°C range; the maximum temperature is 300°C.

Each furnace has its own conveyor system. The two doors can be opened independently of each other to prevent excessive cooling of the furnace during loading and unloading operations (chimney effect).

An intermediate door separating the heat-up section from the holding zones prevents a cold charge from affecting the temperature homogeneity in the holding zones.

The quench tank is made of stainless steel. The lifting/lowering platform is actuated via a hydraulic cylinder. Transferring the charge from the furnace into the quench takes less than 15 seconds.
Propeller-type circulating pumps ensure uniform quenching of the charge and a homogeneous temperature distribution in the water. The tank is equipped with both heating and cooling system.

In the solution proposed here, the exhaust gases from the solution annealing furnace are conducted to the artificial ageing furnace via a single, appropriately insulated duct. This exhaust gas is fed into an external combustion chamber (booster) which is intended to provide additional heating power if required to heat up the artificial ageing furnace (starting from cold at commencement of operations).

Thereafter, the exhaust gases are distributed to the individual zones near the circulating fans. The energy potential of the exhaust gas exiting the solution annealing furnace is thus used for heating the artificial ageing furnace.

Maximum flexibility of the artificial ageing furnace is achieved by installation of four modulating burners in the entry section. These ensure a high input of heating power when required.


To request brochures please contact our sales staff.

  • Tom Schmidt
    +49 2473 601-322
    +49 2473 601-620
    Jaegerhausstr. 22
    D - 52152 Simmerath-Lammersdorf